Talk about the application of CNC spinning machine in industry

1. The tail shaft of the CNC spinning machine can not be smoothly extended: If the cylinder of the spinning machine has an action of moving forward and backward, and the tail shaft cannot advance and retreat, it may be a tail shaft cylinder, which can add smooth treatment to the tail shaft and the oil. In addition, the nut connected to the cylinder and the tail shaft may be loosened. When the nut is locked from the head, the nut is not parallel with the tail shaft. The nut can be loosened, and the tail shaft and the cylinder are returned to the rear end to be aligned and locked. .

2. The tail shaft has an extension, but it does not protrude out of position: The tail shaft has an extension, but the extension does not reach the position or the lock is not in place. You can press the reset button and try again. If you can't handle it, you need to open the tail box to adjust the tail. When the axis travels to the position of the position sensor, if it cannot be processed, it is necessary to determine whether the tail shaft travels to the position sensor and is damaged. The diagnostic screen is called up to check whether the change of the power and power failure of the tail axis of the computer to the position sensor is normal. Move the sensor by hand, and the indicator light is on and off with the change in the computer.

3, the locking in place alarm processing method is the same as above.

4. The tail shaft cylinder does not move: It may be that the solenoid valve is damaged. You can manually press the solenoid valve manual button to perform manual operation. Press and hold the mold clamping, advance and retreat solenoid valve, and the tail shaft travels. Only hold the mold-locking solenoid valve and the tail shaft retreats. Manually normal can determine whether the solenoid valve is damaged, or refer to the condition of the indicator lights of other solenoid valves.

The large-scale CNC spinning machine is mainly used for the cement tanker, and the spinning of the two heads of the gasoline storage tank is because the volume is relatively large, the thickness is thick, and there is no way for the manual to perform the spinning. Generally, the machine is used for the operation. After the two heads are spun, the pressure inside the tank is increased, and the strength and sealing effect of the tank are added. When large-scale spinning does not enter industrial applications, the welding method is used. During the welding process, there are sand holes, and the liquid will flow out through the sand holes. Therefore, the requirements for welding are very high, and the qualification rate of the general welding oil tank is very low and the quality is not good.

After using the spinning head, the area of ??the welded material is very good for improving the qualification rate of the tank.

In recent years, there have been the emergence of super-large spinning machines. For large-scale containers, one can complete the spin-molding process, thoroughly screen the manual welding process, and pass the yield of large-scale containers, and the production power is about 10 times higher than that of welding.